Scan result 1 and 2

[Japiooo]

What's the difference between Scan result 1 and 2?

[MarcoM]

Hi,

Scan Result 1 = OK (No WMI)
The asset was inventoried using only remote registry as WMI is not available. That means that most information could be gathered but some hardware details are missing in inventory data. For more about this check
http://www.loginventory.com/loginventor ... can-errors

Scan Result 2 = OK (SNMP)
The asset was inventoried using SNMP. Those devices are usually Router, Swichtes, Linux etc. running a SNMP client. In this case there are just basic infos of the device gathered. With version 5 there is support for CDP (Cisco Discovery Protocol) providing extended information about Switches (Connected Devices, Interfaces etc.).

Best,

[Japiooo]

Thx, I didn't realize these were seen as errors; but what means the scan result 0?

[MarcoM]

Hmm,

its just OK. Remote Registry and WMI data could be gathered. By the way, Scan Result 2 is not a scan error. It just says that the device does "only" support SNMP.